Instructions for Installing Your New Quooker Boiling Tap Filter
Fitting Instructions for your new Quooker Boiling Water tap water filter *for the first time
Product Code: Inst-Quooker
Thank you again for your order. Please refer to your original manufacturer's instructions as well as the below.
1) Remove Old Filter
- Turn off the power and water supply to your boiling water tap system
- Open your sink top tap to relieve pressure.
- Take old filter and disconnect tubing from both ends
(TIP: To release the "python grip" of the quick connector: Push the collet IN with your thumbnail while pulling the inserted end). You can see a video on this here
2) Fitting Your New Filter
Fitting Your New Filter
First consider where to position your new filter. Then fix the bracket to the wall accordingly - or you can simply use cable ties to secure it into place.
(Measure twice / cut once! ie make sure the tubes are long enough for your desired position).
Best practice is for the filter to be positioned upright with the outlet at the top. But if that's a problem it doesn't matter hugely. (It’s about the water sitting in a flat filter. But that’s only really an issue with large filters).
When positioned, insert the one-time tube adapters to connect the two different size tubes.
(The thinner tubing (¼ inch OD) goes into our filter. You are simply connecting this tube to your existing larger tube going into the tank and water connection.)
Push all the tubes into their adapters firmly. Then give them all a sharp tug to make sure they are held securely.
3) Flush Your New Filter Through
Turn power and water supply back on and run water through for AT LEAST two minutes plus.
This is to remove any natural carbon dust and trapped air.
When water runs clear it’s ready to use.
4) Check for leaks when flushing
AND double check for leaks 10 minutes later.
Any Problems? Please Telephone 020 8761 6611
Important Note re Reminders
To avoid long term bacteria build-up it is important to change or disconnect your water filter on time.
We will email you reminders when it's to change, but please make sure you whitelist our email address so these reminders aren't sent to spam.
And/ or set an alarm now on your mobile or use Siri etc
Please note your feedback and any suggestions as to how we can improve our service are always appreciated.
Sales Admin Team
Telephone 020 8761 6611
Please call us on
020 8761 6611
UK Water Filters Ltd
Parkhall Industrial Centre
UK Water Filters Ltd a Company Limited by Guarantee,
Registered in England,
Company Number: 05249436,
VAT Reg. No. 863 7634 91
Questions? Call us for friendly advice
+44 (0) 20 8761 6611