Instructions for Installing your TP-52 Water filter Tap
Product Code: TP-52
Please follow the instructions below carefully.
VIDEO available. This is for a slightly different model but is much the same.
If you are replacing an existing water filter tap you can simply replace it like-for-like. Ignore the irrelevant sections below eg re drilling the hole
For safety locate your main water STOP COCK before installing
TOOLS Required: Drill - with 12 or 13 mm drill bit. Spanner or pliers
STEP 1: Select the position of the tap on your counter / sink unit. TIP Ensure you have room underneath to connect filter to bottom of tap.
STEP 2: Drill a 12mm hole. TIP use a smaller drill bit first to make a "pilot hole".
STEP 3: Fit the above counter washers to tap tail. These are (in order from top to bottom):
Large chrome washer - this might have a blue removable film on it which you can simply peel off - then
Large / thin washer - this goes against the countertop
(Note: If the plastic tube connector is already connected to the bottom of the tap: In order to fit the washers you can quickly remove the connector. To do this you simply need to push in the collet / small ring - that the tap tail goes into - while pulling the tap tail out. Doing this releases the connector).
(Note: You do not require the large washers in Step 3 if the plastic tube connector is inbuilt to the stem of the tap).
STEP 4: Now insert tap tail through the hole
STEP 5: Secure the tap underneath the counter by using the other Washers.
Hard washer - goes at top ie against the underside of the countertop
The nut that goes onto the tap tail screw thread.
Tighten this all up to secure the tap.
STEP 6: Connect the “quick fit connector” to the bottom of the tap tail. The “quick fit connector” push fits on to the tap tail. Give the connector a sharp tug to make sure it is held securely.
STEP 7: Connect the tubing to the “quick fit connector”. The tubing push fits into the “quick fit connector” Give the tubing a sharp tug to make sure it is held securely.
It should now be ready.
Check for leaks after water starts going through your new tap.
IF YOU NEED ANY HELP Please call us on 020 8761 6611
Please note your feedback and any suggestions as to how we can improve our service are always appreciated.
Thank you
Sales Admin Team
Telephone 020 8761 6611
Water Filter instructions / Guides for fitting and installing
FREE SUPPORT
Need advice?
Please call us on
020 8761 6611
UK Water Filters Ltd
Unit D120
Parkhall Industrial Centre
London
SE21 8DE
UK Water Filters Ltd a Company Limited by Guarantee,
Registered in England,
Company Number: 05249436,
VAT Reg. No. 863 7634 91
Questions? Call us for friendly advice
+44 (0) 20 8761 6611
