Instructions for Replacing Your FLN-PF1 and FLN-Scale

Thank you for your purchase. Here is how to change your filter cartridge.

1) Remove Old Filter

a) Turn off the water supply to your old filter

b) Open your sink top tap to relieve pressure

c) Take old filter and disconnect tubing from both ends

(TIP: To release the "python grip" of the quick connector: Push the collet (ie the little ring that the tube goes into) IN towards the filter while pulling the inserted end AWAY).

2) Fitting Your New Filter

a) Check flow direction

Look for the Flow arrow on the filter.

Arrow points in the direction the water should flow ie to your tap

b) Simply insert the tubing ends into your new filter - follow the same the in/out flow direction

c) Give both ends a sharp tug to make sure they are held securely.

3) Flush Your New Filter Through.

Turn water supply back on and run water through for AT LEAST two minutes plus.

This is to remove natural carbon dust and trapped air.

When water runs clear it’s ready to drink.

4) Check for leaks when flushing AND double check for leaks 10 minutes later.

Important Note re Reminders

To avoid long term bacteria build-up it is important to change or disconnect your water filter cartridges on time.

We will email you reminders when it's time to change, but please make sure you whitelist our email address so these reminders aren't sent to spam.

And/ or set an alarm now on your mobile or use Siri etc

Please note your feedback and any suggestions as to how we can improve our service are always appreciated.

 

Thank you

Sales Admin Team
Telephone 020 8761 6611

Water Filter instructions / Guides for fitting and installing

 

FREE SUPPORT
Need advice?
Please call us on
020 8761 6611

 

UK Water Filters Ltd
Unit D120
Parkhall Industrial Centre
London
SE21 8DE

UK Water Filters Ltd a Company Limited by Guarantee,
Registered in England,
Company Number: 05249436,
VAT Reg. No. 863 7634 91

 

Questions? Call us for friendly advice
+44 (0) 20 8761 6611

mail@uk-water-filters.co.uk